| 000 | 02491nam a2200241 a 4500 | ||
|---|---|---|---|
| 001 | vtls000045831 | ||
| 003 | KUKTEM | ||
| 005 | 20251114204504.0 | ||
| 008 | 100517t2009 my a f m 000 0 engrd | ||
| 020 | _aTHE0007283(Local) | ||
| 039 | 9 |
_a201905141146 _bfawwaz _c201406061050 _dFida _c201406061033 _dFida _c201107132319 _dVLOAD _y201005171205 _zida |
|
| 040 | _aUMP | ||
| 090 | _aTL257 .K43 2009 rs Bc. | ||
| 100 | 0 | _aMohd Khairil Azirul Khairolazar | |
| 245 | 1 | 0 |
_aRobust design of lower arm suspension using stochastic optimization method / _cMohd Khairil Azirul Bin Khairolazar |
| 246 | 3 |
_aRobust design of lower arm suspension using stochastic optimization method _h[electronic resource] |
|
| 260 |
_aKuantan, Pahang : _bUMP, _c2009 |
||
| 300 |
_axiii, 32 p. : _bill. (some col.) ; _c30 cm. + _e1 computer disc |
||
| 502 | _aProject paper (Bachelor of Mechanical Engineering with Automotive Engineering) -- Universiti Malaysia Pahang - 2009 | ||
| 520 | 3 | _aThis project presents the development of robust design of lower suspension arm using stochastic optimization. The strength of the design analyze by finite element software. The structural model of the lower suspension arm was mode by using the solidworks. The finite element model and analysis were performed utilizing the finite element analysis code. The linear elastic analysis was performed using NASTRAN codes. TET10 and TET4 mesh has been used in the stress analysis and the highest Von Mises stress of TET10 has been selected for the robust design parameter. The development of Robust design was carried out using the Monte Carlo approach, which all the optimization parameter for the design has been optimized in Robust design software. The improvements from the Stochastic Design Improvement (SDI) are obtained. The design capability to endure more pressure with lower predicted stress is identified through the SDI process. A lower density and modulus of elasticity of material can be reconsidered in order to optimize the design. The area of the design that can be altered for the optimization and modification is identified through the stress analysis result. As a conclusion, the robust design by using stochastic optimization was capable to optimize the lower arm suspension. Thus, all the result from this project can be use as guideline before developing the prototype. | |
| 650 | 0 |
_aAutomobiles _xSprings and suspension |
|
| 999 |
_aVIRTUA40 _c2886 _d2892 |
||
| 999 | _aVTLSSORT0080*0200*0400*0900*1000*2450*2460*2600*3000*5020*5200*6500*9992 | ||