000 02988nam a2200253 a 4500
001 vtls000052305
003 KUKTEM
005 20251114204504.0
008 110325t2010 my a f m 000 0 eng d
020 _aTHE0007512(Local)
039 9 _a201905161445
_bfawwaz
_c201204231111
_dFida
_c201110040954
_dFida
_c201107140026
_dVLOAD
_y201103251711
_zida
040 _aUMP
090 _aTS156.2 .H69 2010 rs Bc.
100 1 _aHow, Sheng Boon
245 1 0 _aProductivity improvement using industrial engineering tools /
_cHow Sheng Boon
260 _aKuantan, Pahang :
_bUMP,
_c2010
300 _axvii, 77 p. :
_bill. (some col.) ;
_c30 cm. +
_e1 CD-ROM
502 _aProject paper (Bachelor of Mechanical Engineering with Manufacturing Engineering) -- Universiti Malaysia Pahang - 2010
504 _aBibliography : p. 69-70
520 3 _aThe aim of this study is to study the implementation of industrial engineering tools in selected manufacturing company to identify the highest defects occurred at the company production lines and propose new methods to the selected manufacturing company for defects reduction and thus improve the productivity of the company. The chosen company is NamHwa Paper Industries (M) SDN. BHD. and the product being analyzed is 1040mm paper. The study mainly focuses on 7 Quality Control. In order to achieve the objective of the study, firstly, the flow of process to produce 1040mm paper was observed. From the observation, there are total of 8 workstations at the company. The workstations are Slitter, Print, Slotter, Glue, Stitching, Partition, Die Cut and Tie workstation. Then, each frequency of defects at the workstation was collected by using check sheets. The data was then arranged according to the highest to lowest frequency in cumulative table and Pareto chart was build base on the cumulative table. Defect with the highest frequency can be identified and was chosen to be analyzed. The workstation chosen for analyzed was Glue workstation. Initially, the original methods imply at glue workstation has very much defects and did not achieve the targeted output. Hence, brainstorming needs to be done to build the cause and effect diagram as detailed as possible causes in each of the broad areas where the causes will be 4M which is Methods, Machines, Manpower and Materials. Based on the cause and effect diagram, solutions were generated. There are few suggestions that can suite the company and improve the productivity of NamHwa Paper Industries (M) SDN. BHD. The solutions are divided the glue paper box into few group before stacking up, use electric fan or airy place for glue workstation, and use table lamp or hair dryer. Cost reduction for each solution was calculated and the solution with highest cost reduction is chosen to increase the productivity of the company.
650 0 _aIndustrial productivity
650 0 _aQuality control
999 _aVIRTUA40
_c2906
_d2912
999 _aVTLSSORT0080*0200*0400*0900*1000*2450*2600*3000*5020*5040*5200*6500*6501*9992