000 02949nam a2200253 a 4500
001 vtls000058096
003 KUKTEM
005 20251114204510.0
008 111229t2010 my a f m 001 0 eng d
020 _aTHE0005048(Local)
039 9 _a201905140935
_bSHAHRILJ
_y201112291402
_zida
040 _aUMP
090 _aTS1925 .H39 2010 rs Bc.
100 0 _aMohd Hazizul Hamzah
245 1 0 _aMechanical properties of styrene butadiene rubber with oil palm trunk fiber as filler /
_cMohd Hazizul Hamzah
260 _aKuantan, Pahang :
_bUMP,
_c2010
300 _axv, 56 p. :
_bill. (some col.) ;
_c30 cm. +
_e1 CD-ROM
502 _aProject paper (Bachelor of Chemical Engineering) -- Universiti Malaysia Pahang - 2010
504 _aBibliography : p. 46-48
520 3 _aSynthetic rubber on the other hand is a rubber which is synthesized chemically. Styrene-butadiene rubber is one of them. The synthetic rubber gives different properties from natural rubber in every aspect. The objectives of this research are to investigate the mechanical properties changes in styrene butadiene rubber (SBR) filled with oil palm trunks as fillers and to check the differences in properties between the amounts of fillers used. The purpose of this research is to investigate the properties of styrene butadiene rubber blending with oil palm trunk fiber as filler. The research is based on experimental lab research. The contribution of oil palm trunk as a filler in rubber compound will decrease the burning activities and reducing environmental issues. Many researches have been done in rubber/natural filler blending in order to improve the properties of rubber with economically. The methods in this research are divided into three sections; mixing, molding, and testing. Mixing required two roll mills as a device blending rubber with filler, accelerator and vulcanizing agent. Molding required hot and cold press molding to form a sheet of product before testing. Testing required a universal testing machine to test the tensile properties of the rubber blend. Two chemical used in this swelling test; kerosene and diesel. The samples were put into two different bottles with kerosene inside one bottle and diesel inside another bottle. The time taken to complete the test was 24 hours – exactly one day. The result from testing showed that increasing amount of fillers will actually decrease the tensile strength, increase the tensile modulus and increase swelling behavior of the rubber blend. As conclusion, most of mechanical properties decrease with increasing of filler content. As recommendation, increasing the filler content might give the better result, and giving more information about capability of styrene butadiene rubber to consume more filler.
650 0 _aStyrene-butadiene rubber
_xTesting
650 0 _aRubber
_xMechanical properties
999 _aVIRTUA40
_c3074
_d3080
999 _aVTLSSORT0080*0200*0400*0900*1000*2450*2600*3000*5020*5040*5200*6500*6501*9992