000			02067ntm a2200241 a 4500
001			vtls000082987
003			KUKTEM
005			20251114204335.0
008			141104t2013 my da f m 000 0 eng|d
020			_aTHE0005640(Local)
039		9	_a201905171457 _bhanafiah _c201411051001 _dtraining2 _y201411041233 _ztraining2
040			_aUMP
090			_aTA356 .N67 2013 r Bc.
100	1		_aMohamad Norfaiza Anuar Mahmood
245	1	0	_aMeasurement and validation of fluid structure interface / _cMohamad Norfaiza Anuar Mahmood
260			_aKuantan, Pahang : _bUMP, _c2013
300			_axvi, 69 p. : _bill. (some col.) ; _c30 cm. + _e1 CD-ROM
502			_aProject Paper (Bachelor of Mechanical Engineering) -- Universiti Malaysia Pahang – 2013
504			_aBibliography : p. 70-71
520	3		_aThis thesis is done to study about structure of pipeline network when it vibrated. The vibration of the structure can lead to problem. The objectives of the study are to determine the mode shape and natural frequency when the structure is vibrated. Besides that, in this study we also need to verify the data that obtain. The method that will be use to conduct this study is experimental and simulation of pipeline network. In experimental we need to build the pipeline network structure. The design must consider the workplace. In simulation we need to draw the design of pipeline network in solidwork software, the parameter must follow in experimental method. This is because if use different parameter the data between both will be different. After that, comparison of the data between these two methods must be done, this is because the data must be verify whether it valid or not. The result will show the mode shape and natural frequency of structure. If the data is not valid the experiment need to be repeat until get the same data or approximately same. The data will be valid if the error between these two results is below than 5%.
650		0	_aFluid mechanics
999			_aVIRTUA40 _c325 _d331
999			_aVTLSSORT0080*0200*0400*0900*1000*2450*2600*3000*5020*5040*5200*6500*9992