000			02126nam a2200253 a 4500
001			vtls000065536
003			KUKTEM
005			20251114204522.0
008			121101t2012 my da f m 000 0 eng d
020			_aTHE0007507(Local)
039		9	_a201905161442 _bfawwaz _c201211080930 _dhuda _y201211011456 _zhuda
040			_aUMP
090			_aTS156 .S93 2012 rs Bc.
100	0		_aMohamad Syahmi Shahrom
245	1	0	_aTaguchi method approach on effect of lubrication condition on surface roughness in milling operation / _cMohamad Syahmi Shahrom
260			_aKuantan, Pahang : _bUMP , _c2012
300			_axiv, 77 p. : _bill. (some col.); _c30 cm. + _e1 CD-ROM
502			_aProject paper (Bachelor of Manufacturing Engineering) -- Universiti Malaysia Pahang - 2012
504			_aBibliography : p. 71-73
520			_aThis thesis presents an investigation into the MQL (minimum Quantity Lubrication) and wet machining in milling processes of AISI 1060 Aluminum work material with the main objective is to determine the effect of lubrication conditions on the surface roughness. Two types of insert had been used in this research, which is different in geometry selection is radius 0.8mm and 1.2mm. Three other parameters were also considered in this study; feed rate, depth of cut and cutting speed. The levels each parameter had been selected is four levels. The ranges of feed rate 0.05mm/min, 0.15mm/min,0.20mm/min and 0.25mm/min depth of cut used were 0.2mm, 0.4mm, 0.6mm and 0.8mm whereby the cutting speed values were 600mm/min, 800mm/min, 1000mm/min and 1200mm/min. The surface roughness was evaluated using surface roughness tester Mitutoyo. Taguchi method was used to predict the surface roughness. Finally, the experimental results showed good agreement with the estimated results. It was found that, MQL produced better surface finish as compared to wet machining. The result can significantly reduce cost and environmental pollution.
650		0	_aTaguchi methods (Quality control)
650		0	_aSurface roughness
999			_aVIRTUA40 _c3429 _d3435
999			_aVTLSSORT0080*0200*0400*0900*1000*2450*2600*3000*5020*5040*5200*6500*6501*9992