000			02074ntm a2200241 a 4500
001			vtls000072675
003			KUKTEM
005			20251114204536.0
008			130624t2012 my da f m 000 0 eng d
020			_aTHE0005623(Local)
039		9	_a201905171147 _bhanafiah _c201306241643 _dhuda _c201306241532 _dhuda _c201306241532 _dhuda _y201306241532 _zhuda
040			_aUMP
090			_aTA347.F5 N67 2012 rs Bc.
100	0		_aNorsyazwani Badilah
245	1	0	_aEffect of radius of fillet on shear stress for cylindrical shaft / _cNorsyazwani Badilah
260			_aKuantan, Pahang : _bUMP, _c2012
300			_axvi, 57 p. : _bill. (some col.) ; _c30 cm. + _e1 CD-ROM
502			_aProject paper (Bachelor of Mechanical Engineeringwith Automotive) -- Universiti Malaysia Pahang - 2012
504			_aBibliography : p. 38-39
520	3		_aThis project presents an investigation effect of the radius of the fillet on shear stress for cylindrical shaft by using finite element analysis. The shaft has the tendency to fail due to the inappropriate design of fillet radius. Hence, the best models need to design. 18 models were constructed with different ratio two diameters shaft and radius of fillet in SOLIDWORK. These models imported into PATRAN software to analyze the models with different given of the value of torque. In order to simulate torque, MPC RBAR was employed on model. AISI 4130 was selected material for all models. The value for Young Modulus of Elasticity = 206GPa and the Poisson Ratio = 0.3 was used in this analysis. The stress concentration factor was determined to compare the simulation result and equation. As expected, result showed that increased the radius of fillet of shaft reduced the value of shear stress. The ratio of two diameters shaft 1.09 was the best design compared to others because all cases produced the lowest value of shear stress. The value of shear stress was increase when the torque given was increased.
650		0	_aFinite element method
999			_aVIRTUA40 _c3831 _d3837
999			_aVTLSSORT0080*0200*0400*0900*1000*2450*2600*3000*5020*5040*5200*6500*9992