000 02540nam a2200253 a 4500
001 vtls000075720
003 KUKTEM
005 20251114204545.0
008 131023t2013 my da f abm 000 0 eng d
020 _aTHE0002231(Local)
039 9 _a201905241046
_bshamsul
_c201310231254
_dnabilah
_y201310231249
_znabilah
040 _aUMP
090 _aQK898.A55 S93 2012 rs Bc.
100 0 _aSyazwani Sapiee
245 1 4 _aThe extraction of anthocyanin from Clitoria Ternatea (Blue Pea Flower) by using spray dryer /
_cSyazwani Sapiee
260 _aKuantan, Pahang :
_bUMP,
_c2013
300 _axiii, 59 p. :
_bill. ;
_c30 cm. +
_e1 CD-ROM
502 _aProject paper (Bachelor of Chemical Engineering (Biotechnology)) -- Universiti Malaysia Pahang – 2013
504 _aBibliography : p. 53-55
520 3 _aNowadays, interest in anthocyanin pigments shows an increasing tendency due to their possible health benefits as antioxidants, anti-inflammatory, anti-viral, protection from cardiovascular damage, diabetes preventation and vision improvement. Clitoria ternatea, a local flower which also an indigenous climber herbs, has been found to produce pigments mostly anthocyanin. In this research, anthocyanin from Clitoria ternatea, also known as blue pea flower was extracted by using water. The anthocyanin extract were encapsulated by using spray dry method, which three parameters are being studied, that are inlet air temperature, maltodextrin addition, and also feed flow rate. The technique of using spray dryer is preferable as transformation of juices into dry powders is quite hard due to the high sugar and acid contents. The experimental research was done by using Laboratory Scale Spray Dryer SD06AG, with the range of 160°C to 190°C of temperature, maltodextrin addition of 0% to 40% and feed flow rate of 5 ml/min to 20 ml/min. Further analysis on the quality of the powder obtained from spray drying process were verified by measuring total phenol content, anthocyanin content and antioxidant activity by using UV-Vis U 1800 Spectrophotometer at certain wavelengths. Maltodextrin DE10 had been used as carrier in the spray dryer to prevent wall-deposition formation during the process. As result indicates that at 170°C of inlet temperature, with 30 % maltodextrin addition and 10 ml/min of feed flow rate is the best condition to encapsulate CTAE by using spray dry.
650 0 _aAnthocyanins
650 0 _aAngiosperms
999 _aVIRTUA40
_c4076
_d4082
999 _aVTLSSORT0080*0200*0400*0900*1000*2450*2600*3000*5020*5040*5200*6500*6501*9992