| 000 | 01986ntm a2200253 a 4500 | ||
|---|---|---|---|
| 001 | vtls000073183 | ||
| 003 | KUKTEM | ||
| 005 | 20251114204547.0 | ||
| 008 | 130709t2012 my da f m 000 0 eng d | ||
| 020 | _aTHE0005690(Local) | ||
| 039 | 9 |
_a201905211433 _bhanafiah _c201307091515 _dhuda _y201307091515 _zhuda |
|
| 040 | _aUMP | ||
| 090 | _aTA405 .A33 2012 rs Bc. | ||
| 100 | 0 | _aAida Syamsiah Mohd Yusof | |
| 245 | 1 | 0 |
_aInvestigation of heat treatment on weld joint of steel and aluminum / _cAida Syamsiah Mohd Yusof |
| 260 |
_aKuantan, Pahang : _bUMP, _c2012 |
||
| 300 |
_axiv, 47 p. : _bill. (some col.) ; _c30 cm. + _e1 CD-ROM |
||
| 502 | _aProject paper (Bachelor of Mechanical Engineering (Manufacturing)) -- Universiti Malaysia Pahang - 2012 | ||
| 504 | _aBibliography : p. 46-47 | ||
| 520 | 3 | _aDissimilar welding or Tailor Welded Blank (TWB) joint is defined as two or more sheets with equal or different materials, thickness, strength, or surface coatings are welded together. The objective of this project is to investigate the effect of heat treatment on the weld joints quality and determined the mechanical properties of the steel-aluminum weld joint. This project was performed to join aluminum alloy AA1100with stainless steel SUS 304in the thickness range of 3 mm in lap joint configuration. Among theprocess parameters varied were current flow, pre heating process. By metallurgy cross sections, hardness test and tensiletests, the effect of these process parameters on joint properties such as welding joint hardness, macrostructure defect and tensile strength could be elucidated. Based on theseresults, the penetration of the stainless steel with aluminum alloy will occur when the preheating process is applied. The optimum current without preheating is 85A and 95A for preheating process at 85ºC. | |
| 650 | 0 | _aStrenght of materials | |
| 650 | 0 | _aWelded joints | |
| 999 |
_aVIRTUA40 _c4129 _d4135 |
||
| 999 | _aVTLSSORT0080*0200*0400*0900*1000*2450*2600*3000*5020*5040*5200*6500*6501*9992 | ||