000			02079nam a2200229 a 4500
001			vtls000077908
003			KUKTEM
005			20251114204604.0
008			140506t2012 my a m 000 0 eng d
020			_aTHE0005777(Local)
039		9	_a201905101558 _baida _y201405060918 _ztraining3
040			_aUMP
090			_aTA418.7 .L69 2012 rs Bc.
100	1		_aLo, Wei Hou
245	1	0	_aOptimization of cutting parameters and surface roughness on dry turning of low carbon steel / _cLo Wei Hou
260			_aKuantan, Pahang : _bUMP, _c2012
502			_aProject paper (Bachelor of Mechanical Engineering) -- Universiti Malaysia Pahang - 2012
504			_aBibliography : p. 69-70
520	3		_aCutting fluid play a very important role in machining but it also brings a lot of detrimental effects such as health hazards and environmental pollutions when it handled improperly. In addition, the cutting fluids also increase the amount of machining cost since it had been issues lately of its cost frequently higher than the cost of cutting tools. With this issue, dry machining becomes one of the solutions to solve this problem. The objective of this project is to optimize the cutting parameters and surface roughness on dry machining. Material chosen to be perform in this study is low carbon steel AISI 1019. The experiment is carried out with a full factorial design of 3 cutting parameters with 3 levels each onto dry Lathe machining. The surface roughness of workpiece is measured by using perthometer and the result is analyzed statistical by using STATISTICA software version 7.1. The optimum cutting parameters and surface roughness can be investigated through the ANOVA prediction with a level of confident 95 percent. The result investigate can help the industries to solve the problem by applying the investigated values of parameters not only in reducing the machining cost but also present a more environmental friendly machining operation.
650		0	_aSurface roughness
999			_aVIRTUA40 _c4641 _d4647
999			_aVTLSSORT0080*0200*0400*0900*1000*2450*2600*5020*5040*5200*6500*9992