000 02553nam a2200253 a 4500
001 vtls000052304
003 KUKTEM
005 20251114204340.0
008 110325t2010 my a f m 000 0 eng d
020 _aTHE0006550(Local)
039 9 _a201905141533
_bamirul
_c201110040942
_dFida
_c201107131835
_dVLOAD
_y201103251535
_zida
040 _aUMP
090 _aTJ1187 .F39 2010 rs Bc.
100 0 _aFazlina Mansor
245 1 0 _aDesigning and evaluating of jig for holding cylindrical parts for mass production for drilling operation /
_cFazlina Mansor
246 3 _aDesigning and evaluating of jig for holding cylindrical parts for mass production for drilling operation
_h[computer file]
260 _aKuantan, Pahang :
_bUMP,
_c2010
300 _axi, p. :
_bill. (some col.) ;
_c30 cm. +
_e1 computer disc
502 _aProject paper (Bachelor of Mechanical Engineering with Manufacturing Engineering) -- Universiti Malaysia Pahang - 2010
504 _aBibliography : p. [64]
520 3 _aThe project study is about a designing and evaluating of jig for holding cylindrical parts for mass production of drilling operation. Three design were draw and compared in terms of material and also the strength of the jigs to select the best design. This report begin with an introduction of jigs which is definition and important component in jigs and advantages of the jigs. Drilling jig is used whenever it is necessary to drill hole to exact location. The objective of this study is to design and analyze the drilling jig which can hold 30 work-piece of small cylindrical parts. Design were evaluate in terms of force applied to the jig. Three new jig were designed using SolidWorks software. The design were analyze using FEA tools which is Algor software. Pugh Concept Selection also applied in selection the best design. Material AISI 1040, AISI 1018 and Iron, Fe selected to make analysis and as the result, material AISI 1040 were chosen for the jig. Design also evaluate by using two difference force value which is 400 N and 1000 N to choose the strongest design. The results for force 400 N showed that design 3 have lowest maximum von mises value with 0.5660021 N/mm2 compared to design 1 with 1.066816 N/mm2 and design 2 with 37.70809 N/mm2. Design 3 were selected to be the final design and AISI 1040 selected as the jig material because it strongest compared to AISI 1018 and Iron, Fe.
650 0 _aJigs and fixtures
_xDesign and construction
999 _aVIRTUA40
_c483
_d489
999 _aVTLSSORT0080*0200*0400*0900*1000*2450*2460*2600*3000*5020*5040*5200*6500*9992