000 03209ntm a2200277 a 4500
001 vtls000084864
003 KUKTEM
005 20251117113241.0
008 150114t2014 my a f m 000 0 eng d
020 _aTHE0003037(Local)
039 9 _a201905141536
_bzul
_c201711301139
_dhuda
_y201501141511
_zfawwaz
040 _aUMP
090 _aTD195.P36 A45 2014 r Bc.
100 0 _aAhmad Amirul Asraf Mohd Daud
245 1 0 _aPalm oil waste gasification: the effect of operating temperature for hydrogen production /
_cAhmad Amirul Asraf Mohd Daud
260 _aKuantan, Pahang :
_bUMP,
_c2014
300 _axv, 36 p. :
_bill. ;
_c30 cm. +
_e1 CD-ROM
500 _aFaculty of Chemical & Natural Resources Engineering
502 _aProject paper (Bachelor of Chemical Engineering) -- Universiti Malaysia Pahang – 2014
504 _aBibliography : p. 24-27
520 3 _aThe production of synthesis gas from the gasification of palm oil waste; Kernel Shell, (KS) and Mesocarp Fibre, (MF) has been studied using a small lab scale gasification unit. The effect of operating temperature on the sample for the products yield and composition were investigated. The sample was collected, cleaned, dried, resized and gone through CHNS analysis prior to be used as the feedstock. Initially, approximately three grams of sample was used. Reactor and condenser were weighted before and after the gasification process in order to know the weight percent of solid, liquid and gas for each sample. Nitrogen gas; N2 was first purged at 50 ml/min into the reactor as the carrier gas to remove gases in the system for about 20 minutes. It was done to achieve oxygen free atmosphere in order to avoid any explosion. After that, the flowrate was increased to 100 ml/min and the furnace was turned on to the desired temperature. The products which were syngas and bio-liquid from the gasification were firstly flown into the condenser. Then, the uncondensed gases were flew into a 12 L gas sampling bag and analyzed via Gas Chromatography, GC. The liquid product was trapped in the condenser. The gasification process was done in one hour. The effect of operating temperature has influenced the yield of bio oil, syngas and char for the samples (KS and MF). The highest syngas produced from MF and KS was obtained at 900 oC. As the temperature increased, the product yield of bio-oil and char were decreased. The highest amount of Hydrogen gas produced for both samples was obtained at 900 oC and it can be deduced that 900 oC is the optimum temperature for the gasification process. The composition of the syngas produced was identified using Gas Chromatography (GC). The result showed that the Hydrogen composition in MF is higher than KS. The studies on the production of Hydrogen gas from the gasification of KS and MF showed that the Hydrogen obtained from the KS and MF might be a potential valuable source for renewable fuel and for the usage of chemical feed stocks
650 0 _aHydrogen
650 0 _aPalm oil industry
_xWaste disposal
856 4 0 _uhttp://ecollib.ump.edu.my/18343/
_zAccess in library only
999 _aVIRTUA40
_c5446
_d5452
999 _aVTLSSORT0080*0200*0400*0900*1000*2450*2600*3000*5000*5020*5040*5200*6500*6501*8560*9992