000 02802ntm a2200265 a 4500
001 vtls000084656
003 KUKTEM
005 20251117113245.0
008 141224t2014 my a f m 000 0 eng d
020 _aTHE0003191(Local)
039 9 _a201905161441
_bzul
_c201712051554
_dhuda
_y201412240952
_zfawwaz
040 _aUMP
090 _aTD466 .A85 2014 r Bc.
100 0 _aNur Atifah Ahmad Kamil Saraidin
245 1 0 _aInfluence of temperature and heating rates on calcination of waste cockle shells to calcium oxides/
_cNur Atifah Ahmad Kamil Saraidin
260 _aKuantan, Pahang :
_bUMP,
_c2014
300 _axiv, 62 p. :
_bill. ;
_c30 cm. +
_e1 CD-ROM
500 _aFaculty of Chemical & Natural Resources Engineering
502 _aProject paper (Bachelor of Chemical Engineering) -- Universiti Malaysia Pahang – 2014
504 _aBibliography : p. 61
520 3 _aCockle shells or Anadara granosa has been touted as an alternative for the calcium carbonate sources instead of using the limestone. Mining large quantities of rocks can contribute to the environmental damage and engage with the high cost for environmental compliance. Li et al. (2009) also proved that seashells to have higher composition of calcium oxides compared to the limestones. In this research, the shells of Malaysian blood cockle, Anadara granosa, were used as the starting material. The present study was done to evaluate the influence of operating conditions on the minerals of Anadara granosa shells by heat treatment at various temperatures and heating rates, and to subsequently use the resulting material for the formation of calcium oxide. CaO associated with carbonaceous material has been of recent interest in applications such as transesterification catalysts and sorbents for sulphur dioxide. The utilisation of the economic resources of waste bio-minerals from blood cockle shells is expected to promote the commercial application of the resulting calcium oxides. Calcination of cockle shells was analysed with TGA with different range of temperature (700, 750, 800, 850 and 900oC) and heating rates at 10oC/min and 20oC/min. Overall, the better performance is shown at the calcination temperature of 800oC for 39 minutes and heating rate of 20oC/min under N2 gas flow of 40mL/min. Then, the characterization of the cockle shells are done by the FTIR spectrophotometer which is performed in a range of 4000cm-1 to 400 cm-1 with a resolution of 2 cm-1 and averaging of 62 scans. As result, the FTIR analysis showed that the waste cockle shell from the seashore gave the peak of 1472.99cm-1
650 0 _aCalcium carbonate
856 4 0 _uhttp://ecollib.ump.edu.my/18327/
_zAccess in library only
999 _aVIRTUA40
_c5588
_d5594
999 _aVTLSSORT0080*0200*0400*0900*1000*2450*2600*3000*5000*5020*5040*5200*6500*8560*9992