000			03193ntm a2200289 a 4500
001			vtls000094238
003			KUKTEM
005			20251117113318.0
008			160404t2015 my a f 000 0 eng d
020			_aTHE0005365(Local)
039		9	_a201905151217 _bhanafiah _c201711291005 _dfateeha _y201604041140 _zhuda
040			_aUMP
090			_aFKP .J69 2015 r Bc.
100	0		_aMohd Jozaimi Izwan Jalaluddin
245	1		_aAquarium pump drive by solar cell using maximum power point tracking (MPPT) / _cMohd Jozaimi Izwan Jalaluddin
260			_aKuantan, Pahang : _bUMP, _c2015
300			_axiv, 79 p. : _bill. (some col.) ; _c30 cm. + _e1 CD-ROM
500			_aFaculty of Manufacturing Engineering
502			_aProject Paper (Bachelor of Mechatronic Engineering) -- Universiti Malaysia Pahang – 2015
504			_aBibliography: p. 52-53
520	3		_aThis thesis proposes the implementation of solar panel as an alternative that could generates electricity from sunlight exposure. The renewable energy that produced by solar could be used in supplying electricity to electrical equipment as well as becoming an alternative source apart from the available energy supplied by the utility. The main objective of this project is to supply the electrical energy to aquarium pump. Besides that, the maximum power point tracking (MPPT) is used to increase the power conversion efficiency of solar panel. Fuzzy logic controller is one of the MPPT method is used in this project and sun tracking system was added in this project to increase the power absorption by the solar panel. This sun tracking system embedded with light dependent resistor (LDR) which acts as a light sensor while the microcontroller is used for receiving and analysing input signal from LDR and sending the output signal to the DC motor. DC motor will be the medium for moving the solar panel towards the direction of the sun. The purpose of moving the solar panel towards the direction of the sun is to increase the rate of sunlight absorption by the solar panel hence increasing the electrical energy produced by solar panel. The method of fuzzy logic controller implemented using Arduino Uno to control MOSFET that contained in the dc-dc boost converter. Control signal produced by Arduino Uno will be sent to optocouple circuit as to increase the suitable voltage value to control the MOSFET. This method also presenting real-time code of fuzzy logic in Arduino language for controlling ATmega328 that contained in Arduino Uno board. The result obtained through the coding of Arduino is the variation of duty cycle of PWM signal according to the voltage of solar panel. The final result obtained from dc-dc boost converter showed that the output voltage has been regulated. Overall, the fuzzy logic controller was increases the efficiency of the overall system by24.4965%.
610	2		_aFaculty of Manufacturing Engineering _xDissertations
650		0	_aUniversities and Colleges _xDissertations
650		0	_aTheses
856	4	0	_uhttp://ecollib.ump.edu.my/id/eprint/25978 _zAccess in library only
999			_aVIRTUA40 _c6534 _d6540
999			_aVTLSSORT0080*0200*0400*0900*1000*2450*2600*3000*5000*5020*5040*5200*6100*6500*6501*8560*9992