| 000 | 01897nmm a2200313 a 4500 | ||
|---|---|---|---|
| 001 | vtls000098440 | ||
| 003 | KUKTEM | ||
| 005 | 20251117113331.0 | ||
| 008 | 161214s2016 my fq d 001 0 eng d | ||
| 020 | _aTHE0005113(Local) | ||
| 039 | 9 |
_a201905131513 _bhanafiah _c201712121405 _dfateeha _y201612141019 _zsaini |
|
| 040 | _aUMP | ||
| 090 | _aFKP .A363 2016 r Bc. | ||
| 090 | _aCD 10444 | ||
| 100 | 0 | _aMuhammad Aiman Ishak | |
| 245 | 1 | 0 |
_aDevelopment of ceramics cutting tool for machining using aluminium oxide reinforced with copper powder _h[electronic resource] / _cMuhammad Aiman Ishak |
| 260 |
_aKuantan, Pahang : _bUMP, _c2016 |
||
| 300 |
_a1 computer disc : _bdigital data ; _c12 cm. |
||
| 500 | _aFaculty of Manufacturing Engineering | ||
| 500 | _aTheses Gred B | ||
| 502 | _aProject Paper (Bachelor of Engineering in Manufacturing Engineering (Hons.)) -- Universiti Malaysia Pahang – 2016 | ||
| 520 | 3 | _aPowder metallurgy (processing) method was used to produce an insert for machining application. An alumina (Al2O3) powder reinforced with Copper power was used as a raw material. A complete die was produced for the insert production. Powder mixing, compaction and sintering using open air furnace were the main processing parameters in the research project. The composite insert was analyzed for density and hardness properties. The result showed that 90% of the theoretical density was achieved and 70% by weight mixed with 30% copper was measured for the higher Vickers hardness value. | |
| 538 | _aItem in PDF format | ||
| 610 | 2 | 0 |
_aFaculty of Manufacturing Engineering _xDissertations |
| 650 | 0 |
_aUniversities and Colleges _xDissertations |
|
| 650 | 0 | _aTheses | |
| 856 | 4 | 0 |
_uhttp://ecollib.ump.edu.my/id/eprint/3971 _zAccess in library only |
| 999 |
_aVIRTUA40 _c6900 _d6906 |
||
| 999 | _aVTLSSORT0080*0200*0400*0900*0901*1000*2450*2600*3000*5000*5001*5020*5200*5380*6100*6500*6501*8560*9992 | ||