| 000 | 02260nmm a2200313 a 4500 | ||
|---|---|---|---|
| 001 | vtls000098445 | ||
| 003 | KUKTEM | ||
| 005 | 20251117113331.0 | ||
| 008 | 161214s2016 my fq d 001 0 eng d | ||
| 020 | _aTHE0005115(Local) | ||
| 039 | 9 |
_a201905131517 _bhanafiah _c201712131229 _dfateeha _y201612141034 _zsaini |
|
| 040 | _aUMP | ||
| 090 | _aFKP .A365 2016 r Bc. | ||
| 090 | _aCD 10446 | ||
| 100 | 0 | _aNurul Aini Yunus | |
| 245 | 1 | 0 |
_aMicro-milling of Ti-6Al-4V material _h[electronic resource] / _cNurul Aini Yunus |
| 260 |
_aKuantan, Pahang : _bUMP, _c2016 |
||
| 300 |
_a1 computer disc : _bdigital data ; _c12 cm. |
||
| 500 | _aFaculty of Manufacturing Engineering | ||
| 500 | _aTheses Gred B | ||
| 502 | _aProject Paper (Bachelor of Engineering in Manufacturing Engineering (Hons.)) -- Universiti Malaysia Pahang – 2016 | ||
| 520 | 3 | _aMicro-end milling is one of the promising methods for rapid fabrication of features with 3D complex shapes. However, controlling the micro-end milling process to obtain the desired results is much harder compared to that of macro-end milling due to the size effect and uncontrollable factors. The problem is much pronounced when workpiece material is a difficult-to-process material such as titanium-based alloys which are widely used as material of choice for medical implants. This research is about the effect of machining parameters in terms of feed rate and depth of cut with constant spindle speed in wet and dry condition on Ti-6Al-4V's surface roughness using micro-milling process. This experiment was design using Design of Experiment (DOE) method and few numbers of experiments were constructed. The results show that feed rate is the most critical parameter which effect on surface roughness during machining process followed by depth of cut. Dry condition shows better surface quality compared to wet condition. | |
| 538 | _aItem in PDF format | ||
| 610 | 2 | 0 |
_aFaculty of Manufacturing Engineering _xDissertations |
| 650 | 0 |
_aUniversities and Colleges _xDissertations |
|
| 650 | 0 | _aTheses | |
| 856 | 4 | 0 |
_uhttp://ecollib.ump.edu.my/id/eprint/4013 _zAccess in library only |
| 999 |
_aVIRTUA40 _c6902 _d6908 |
||
| 999 | _aVTLSSORT0080*0200*0400*0900*0901*1000*2450*2600*3000*5000*5001*5020*5200*5380*6100*6500*6501*8560*9992 | ||