000			02105nmm a2200313 a 4500
001			vtls000098459
003			KUKTEM
005			20251117113332.0
008			161214s2016 my fq d 001 0 eng d
020			_aTHE0005122(Local)
039		9	_a201905131524 _bhanafiah _c201712261213 _dnazri _y201612141230 _zsaini
040			_aUMP
090			_aFKP .C46 2016 r Bc.
090			_aCD 10453
100	1		_aChoo, Chee Hua
245	1	0	_aSurface modification using EDM wire cut method _h[electronic resource] : _ba feasibility study / _cChoo Chee Hua
260			_aKuantan, Pahang : _bUMP, _c2016
300			_a1 computer disc : _bdigital data ; _c12 cm.
500			_aFaculty of Manufacturing Engineering
500			_aTheses Gred A
502			_aProject Paper (Bachelor of Engineering in Manufacturing Engineering (Hons.)) -- Universiti Malaysia Pahang – 2016
520	3		_aWire electrical discharge machining wire EDM removes electrical conductive materials by the electrical sparks. This research is focused on the surface integrity and the process parameters of the selected materials eg. steel and A-alloy. It is expected that grain refinement occurred due to rapid solidification of molten metal on the surface. So, hardness of material can be increase. Recast layer formed on the metal surface by wire EDM is expected to be harder than the subsurface, due to the rapid-cooling of the molten metal. Present work attempts to identify the effect of various EDM parameters on the layer formation. A preliminary metallurgical investigation of EDM machined surface was conducted to determine the effect of process parameters like wire speed and spindle feed rate to morphology and microstructure change of work piece.
538			_aItem in PDF format
610	2	0	_aFaculty of Manufacturing Engineering _xDissertations
650		0	_aUniversities and Colleges _xDissertations
650		0	_aTheses
856	4	0	_uhttp://ecollib.ump.edu.my/id/eprint/4065 _zAccess in library only
999			_aVIRTUA40 _c6942 _d6948
999			_aVTLSSORT0080*0200*0400*0900*0901*1000*2450*2600*3000*5000*5001*5020*5200*5380*6100*6500*6501*8560*9992