| 000 | 02595nmm a2200313 a 4500 | ||
|---|---|---|---|
| 001 | vtls000098401 | ||
| 003 | KUKTEM | ||
| 005 | 20251117113345.0 | ||
| 008 | 161213s2016 my fq d 001 0 eng d | ||
| 020 | _aTHE0005091(Local) | ||
| 039 | 9 |
_a201905131448 _bhanafiah _c201712081541 _dsaini _y201612131504 _zsaini |
|
| 040 | _aUMP | ||
| 090 | _aFKP .W66 2016 r Bc. | ||
| 090 | _aCD 10420 | ||
| 100 | 1 | _aWong, Choon Fuan | |
| 245 | 1 | 0 |
_aModelling and simulation of side milling using finite element analysis _h[electronic resource] / _cWong Choon Fuan |
| 260 |
_aKuantan, Pahang : _bUMP, _c2016 |
||
| 300 |
_a1 computer disc : _bdigital data ; _c12 cm. |
||
| 500 | _aFaculty of Manufacturing Engineering | ||
| 500 | _aTheses Gred B | ||
| 502 | _aProject Paper (Bachelor of Engineering in Manufacturing Engineering (Hons.)) -- Universiti Malaysia Pahang – 2016 | ||
| 520 | 3 | _aThis project deals with modelling and simulation of side milling using Finite Element Analysis. The objective of this thesis is to validate the cutting force result between simulation and experiment. It describes how the finite element analysis predicts the cutting force before the machining process is proceeded. The data obtained in this project were cutting force and stress during the side milling process. Machining parameters such as cutting speed, feed rate, spindle speed were also studied. The cutting force and stress prediction was done by using finite element analysis software called ABAQUS. The finite element analysis was analyzed based on the interaction between aluminium 6061 work piece and high speed steel tool cutter. The cutting forces were measured by using dynamometer during the side milling process. The machining parameters were calculated before the experiment started. Finally, the cutting force in the three directions which is X, Y and Z direction versus time was measured and recorded in the data acquisition software which is Dyno-ware. From the results of dynamometer, noise has been eliminated to get the certain time period of cutting force. The results between simulation and experiment indicates that the predicted and the measured cutting force of milling process are in a good agreement. | |
| 538 | _aItem in PDF format | ||
| 610 | 2 | 0 |
_aFaculty of Manufacturing Engineering _xDissertations |
| 650 | 0 |
_aUniversities and Colleges _xDissertations |
|
| 650 | 0 | _aTheses | |
| 856 | 4 | 0 |
_uhttp://ecollib.ump.edu.my/id/eprint/4016 _zAccess in library only |
| 999 |
_aVIRTUA40 _c7295 _d7301 |
||
| 999 | _aVTLSSORT0080*0200*0400*0900*0901*1000*2450*2600*3000*5000*5001*5020*5200*5380*6100*6500*6501*8560*9992 | ||