000			02012nam a2200253 a 4500
001			vtls000045549
003			KUKTEM
005			20251114204352.0
008			100504t2009 my a f m 000 0 eng d
020			_aTHE0007460(Local)
039		9	_a201905161232 _bfawwaz _c201204051129 _dFida _c201107132044 _dVLOAD _y201005041348 _zida
040			_aUMP
090			_aTP1150 .D47 2009 rs Bc.
100	0		_aSiti Dermira Arifin
245	1	0	_aDesign of three plate mould and cooling channels analysis/ _cSiti Dermira Binti Arifin
260			_aKuantan, Pahang : _bUMP, _c2009
300			_a70 p. : _bill. (some col.) ; _c30 cm. + _e1 CD-ROM
502			_aProject paper (Bachelor of Mechanical Engineering with Manufacturing Engineering) -- Universiti Malaysia Pahang - 2009
504			_aIncludes bibliographical references
520	3		_aNowadays, demands on product base on plastic is increase from day to day because the product that made from plastic are capable of competing with any other product that made from other sources of raw material in terms of its quality. It is also cheaper compare to any other materials and also the manufacturing process of making these plastics product take shorter time than the other material. In order to manufacture the plastics product with a very good quality, some process should be done and the most important process in the design stage.Because of it, it can be produce in many type of mould such as three-plate mould, two-plate mould, hot runner mould and also cold runner mould. In order to obtain a perfect product without any defect some flow analysis on the product will be conduct. This study will use the Moldflow Plastic Insight (MPI) software in analysing the product. The analyses of the cooling channels location will also being done so that to make sure a constant plastics flow obtain.
650		0	_aInjection molding of plastics
650		0	_aPlastics _xMolding
999			_aVIRTUA40 _c835 _d841
999			_aVTLSSORT0080*0200*0400*0900*1000*2450*2600*3000*5020*5040*5200*6500*6501*9992