| 000 | 02275nam a2200265 a 4500 | ||
|---|---|---|---|
| 001 | vtls000045508 | ||
| 003 | KUKTEM | ||
| 005 | 20251114204353.0 | ||
| 008 | 100504t2009 my a f m 000 0 eng d | ||
| 020 | _aTHE0005866(Local) | ||
| 039 | 9 |
_a201905141023 _baida _c201107132045 _dVLOAD _c201005040913 _dida _c201005040905 _dida _y201005040902 _zida |
|
| 040 | _aUMP | ||
| 090 | _aTA460 .F58 2009 rs Bc. | ||
| 100 | 0 | _aAhmad Fitri Zainal Abidin | |
| 245 | 1 | 0 |
_aEndurance limit of aluminum, brass and mild steel on different surface finish owing to cyclic loads / _cAhmad Fitri Zainal Abidin |
| 246 | 3 |
_aEndurance limit of aluminum, brass and mild steel on different surface finish owing to cyclic loads _h[electronic resource] |
|
| 260 |
_aKuantan, Pahang : _bUMP, _c2009 |
||
| 300 |
_axv, 51 p. : _bill. (some col.) ; _c30 cm. + _e1 computer disc |
||
| 502 | _aProject paper (Bachelor of Mechanical Engineering) -- Universiti Malaysia Pahang - 2009 | ||
| 504 | _aBibliography : p. [46]-48 | ||
| 520 | 3 | _aThe investigation is about the endurance limit of aluminum, brass and mild steel that has been done at the surface of the specimens on different surface roughness. The endurance limit of the specimens have been determined by testing under different loads on the fatigue testing machine and the life cycles of each specimens has been taken after crack occur on the specimen. Endurance limit is defined as the alternating stress that causes failures after some specified number of cycles. This study or investigation has the steps that is starting form the fabrication on different surface roughness, testing on the fatigue machine and gather all the data to compare the results.. The different surface roughness will give different life cycles. Then, comparison of the result needs to be done to get the best materials on different surface roughness to create a good choosing of materials in industry. Finally, studies of Endurance limit or fatigue strength can still be expanded and widened due to the other properties that can be tested such as curvature radii and elongation of the materials due to a break point. | |
| 650 | 0 | _aMetal-cutting | |
| 650 | 0 | _aMachining | |
| 999 |
_aVIRTUA40 _c849 _d855 |
||
| 999 | _aVTLSSORT0080*0200*0400*0900*1000*2450*2460*2600*3000*5020*5040*5200*6500*6501*9992 | ||