000 02407nam a2200241 a 4500
001 vtls000037995
003 KUKTEM
005 20251114204358.0
008 090617t2008 my a f m 000 0 eng|d
020 _aTHE0006110(Local)
039 9 _a201905151518
_baida
_c201107132138
_dVLOAD
_c200908141631
_dVLOAD
_c200908141605
_dVLOAD
_y200906170952
_zida84
040 _aUMP
090 _aTJ213 .A23 2008 rs Bc.
100 0 _aAbdul Latif Aizat Mohamad Haniff
245 1 0 _aSpeed control of DC motor using pole placement controller implementation with PLC/
_cAbdul Latif Aizat Bin Mohamad Haniff
246 3 _aSpeed control of DC motor using pole placement controller implementation with PLC
_h[electronic resource]
260 _aKuantan, Pahang :
_bUMP,
_c2008
300 _a79 p. :
_bill. (some col.) ;
_c30 cm. +
_e1 computer disc
502 _aProject paper (Bachelor of Electrical Engineering (Electronics)) -- Universiti Malaysia Pahang - 2008
520 _aMotor speed control is very important in rotating machinery applications. There are many applications that have been developed based on motor speed control theory, such as conveyor. The idea of motor speed control is to take a signal representing the demanded speed, and to drive a motor at that speed. The purpose of this project is to develop the Pole Placement controller to control the speed of DC motor and implement the controller into Ladder Diagram which connected to PLC. By using Pole Placement controller, the DC motor will rotating at the demanded speed which is set by the user with minimum error. Before the controller was developed, numbers of simulations were done using M-FILE (prompt) and MATLAB Simulink. The objective of the simulation is to evaluate the system response of the DC Motor in with and without controller. The used of PLC in this project will help to reduce complexity and made troubleshooting a very easy task to do. The model of PLC which is used in this project is OMRON (CQM1H-CPU51) and the program for this controller system is in ladder diagram (CX Programmer). The Pole Placement controller is implementing in the PLC program so that this system has a better response and less error. Finally, analysis of the response is made after the Pole Placement is implemented into the system.
650 0 _aAutomatic control
999 _aVIRTUA40
_c998
_d1004
999 _aVTLSSORT0080*0200*0400*0900*1000*2450*2460*2600*3000*5020*5200*6500*9992