Normal view MARC view ISBD view

Automation of 6 wheels robot (HOBO L3A1 robot) / Norfadilah Che Yusoff

By:

Norfadilah Che Yusoff

Material type: Text

TextPublication details: Kuantan, Pahang : UMP, 2012Description: xiv, 62 p. : ill. (some col.) ; 30 cm. + 1 CD-ROMISBN:

THE0006080(Local)

Subject(s):

Dissertation note: Project paper (Bachelor of Electrical Engineering (Electronics)) -- Universiti Malaysia Pahang - 2012 Abstract: The project is about to design a system which enables the 6 wheel robots named HOBO L3A1 ATM automated. A joystick acts an input to the system which embedded on board by interfacing with microcontroller and must be programmed according to expected result to make the robot in functions. The motor speed direction is controlled by developing H-bridge circuits which interface with microcontroller. The robot consists of 6 wheels of different motors that controlled the robot wheels. The overall robot chassis had finished which was designed with motor controls that driven by independent motor, thus the HOBO ATM robot conveniently switch its locomotion modes according to theoperational. This project should be done in accordance with planning requirements. A microcontroller Arduino AtMega1280/2560 was needed in order to achieve the objectives of the project. An appropriate command need to transfer to the microcontroller. The embedded control system is not done yet, so a control system needs to be established to make the robot automated and functioned as well. The method for this project is designing a schematic diagram of circuit then implemented onto board. The microcontroller was programmed according to desired output. At the end of project,it was expected that the robot wheels can automate after the joystick (input) is controlled.

Tags from this library: No tags from this library for this title. Log in to add tags.

Average rating: 0.0 (0 votes)

Holdings ( 2 )
Title notes ( 3 )

Holdings
Item type	Current library	Call number	Copy number	Status	Date due	Barcode
Final Year Report	UMPLIB PEKAN	TJ211.35 .F33 2012 rs Bc. (Browse shelf(Opens below))	1	Not for loan		0000071260
Final Year Report	UMPLIB PEKAN	CD 6726 \| TJ211.35 .F33 2012 rs Bc. (Browse shelf(Opens below))	1	Not for loan		0000071261

Project paper (Bachelor of Electrical Engineering (Electronics)) -- Universiti Malaysia Pahang - 2012

Includes bibliographical references

The project is about to design a system which enables the 6 wheel robots named HOBO L3A1 ATM automated. A joystick acts an input to the system which embedded on board by interfacing with microcontroller and must be programmed according to expected result to make the robot in functions. The motor speed direction is controlled by developing H-bridge circuits which interface with microcontroller. The robot consists of 6 wheels of different motors that controlled the robot wheels. The overall robot chassis had finished which was designed with motor controls that driven by independent motor, thus the HOBO ATM robot conveniently switch its locomotion modes according to theoperational. This project should be done in accordance with planning requirements. A microcontroller Arduino AtMega1280/2560 was needed in order to achieve the objectives of the project. An appropriate command need to transfer to the microcontroller. The embedded control system is not done yet, so a control system needs to be established to make the robot automated and functioned as well. The method for this project is designing a schematic diagram of circuit then implemented onto board. The microcontroller was programmed according to desired output. At the end of project,it was expected that the robot wheels can automate after the joystick (input) is controlled.